Create your own banner at mybannermaker.com!    

1877-477-5452 or apluswater@hotmail.com M-F 9am-5pm CST

Toll Free Support During Installation & Programming!!! Customer Feedback

HomeWater SoftenersEradicatorsIron FitlersReverse OsmosisSediment FiltersCarbon FiltersSoftener PartsText KitsPh FiltersPressure TanksInstall Manuals

Softener Installation Directions:
HOOK THE GARDEN HOSE FROM YOUR WATER SUPPLY, TO THE INLET OFF THE HEAD. THIS IS MARKED     WITH AN IN ARROW.
THE BEST WAY IS TO PURCHASE A SHORT 4 FOOT HOSE FOR A WASHING MACHINE, AND USE THIS AS THE FEED WATER TO THE SOFTENER.
TAKE ANOTHER HOSE AND HOOK IT INTO THE OUT ARROW ON THE SOFTENER, AND YOU ARE READY FOR USE.


Regeneration Directions:

TO REGENERATE YOUR SOFTENER, FIRST REMOVE THE LID FROM THE TOP OF THE SOFTENER BY HAND.


POOR THE LARGE MORTONS TABLE SALT INTO THE HOLE.  (PICTURED BELOW)

 

REPLACE CAP AND LET SIT FOR AT LEAST 1 HOUR. TURN WATER ON AND LET FLUSH FOR 5-10 MINUTES. (THE EASY WAY TO CHECK TO SEE IF SALT IS FLUSHED OUT IS TO TAKE YOUR FINGER AND TASTE TEST THE OUT COMING WATER).
YOUR SOFTENER IS THEN READY TO GO AGAIN.
THIS IS DONE OVER AND OVER AGAIN, AND THE MEDIA DOES NOT NEED REPLACED FOR AT LEAST 2-3 YEARS. (WE HAVE REPLACEMENT MEDIA AVAILABLE FOR YOU IF NEEDED)

1877-477-5452 or apluswater@hotmail.com M-F 9am CST

Check out our customer Feedback





 

Copyright © Aplus Water LLC 2014

Notice: consumer is responsible for following any state and/or local regulations and plumbing codes pertinent to the purchase, installation and operation of our products.